You are here: Manual / PropagationModels / SE42 propagation plug-in

---

SE42 propagation model plugin

Introduction

Following the request of the SE42 meeting 18 (1-3 April) in Estoril (Portugal), STG has developed and validated SEAMCAT propagation plugins.

(If you have comments they may be sent to STG ( ''SEAMCAT Technical Group'') or directly to Mr. Jean-Philippe Kermoal (kermoal@…) chairman of the STG.)

Plugins

The plugins (.class) and their source codes (.java) are freely downloadable from this page.

name of the file	download	environment	indoor/outdor	htx (m)	hrx (m)	Param1	Param2	Param3
table 9	here	Urban Small	outdoor	200	1.5	-	-	-
table 10	here	Urban Small	outdoor	200	10	-	-	-
table9_indoor	here	Urban Small	indoor	200	1.5	default 8 dB (att. wall loss)	default 5.5dB (std. wall loss)	-
table 3_indoor	here	Urban Small	indoor	30	1.5	default 8 dB (att. wall loss)	default 5.5dB (std. wall loss)	-

Test/calibration

Calibration test can be found here.

How to load the plugins

Load the .class file (see above) on your SEAMCAT plugin folders (see plugin section) and go to sub-section “How to add your plugin to Seamcat”